Collection:
Black Network Cables
Shop black Cat5e, Cat6 and Cat6A patch leads in stock now at TechLoop, with fast Australia-wide delivery.
161 products
Filter
StarTech.com
StarTech CAT6 7.5m Black Snagless PoE Ethernet Cable 250MHz 24AWG
Choose your option
Which black network cable do you actually need?
Most PC builders grab the first black Ethernet lead they see and only find out later that it was the wrong category for their router, switch or board. The jacket colour is cosmetic, so the real decision is the cable grade underneath it. Cat5e is the entry tier, rated to 100 MHz. It handles gigabit comfortably and will run 2.5GbE over normal home distances, which covers most modern Motherboards with a 2.5G port. Cat6 is the sweet spot for most people. It is rated to 250 MHz, has tighter twist rates and often a internal spline separator, and it can carry 10GbE up to roughly 55 metres. Cat6a doubles that to 500 MHz and holds 10GbE for the full 100 metres, but the extra shielding makes it thicker and stiffer.
Diminishing returns hit fast. A Cat8 cable is rated to 2000 MHz for 25G and 40G, but only over about 30 metres, and it is designed for datacentre switch-to-server runs. Your ISP plan, router and NIC will bottleneck long before the cable does. Cat7 is a grey area because it was never recognised by TIA and normally needs non-RJ45 connectors, so a Cat7 lead with a standard plug is really a marketing label. For most home and gaming setups, solid Cat6 or Cat6a is the right ceiling.
Upgrading and technical nuances
The biggest trap in this category is conductor material. Genuine pure copper cable carries signal and PoE power with low resistance. Copper-clad aluminium (CCA) is cheaper, has higher resistance and is more brittle. It can run warm under PoE loads, and it often fails to reach full speed at length. Look for "pure copper" or "bare copper" on the listing, and for the cable category printed along the jacket itself.
Gauge matters too. Standard Cat6 uses 23 to 24 AWG conductors. Slim and flat patch leads often drop to 28 AWG to stay flexible, and that is fine for short runs of 1 to 3 metres. Flat cables are also more prone to crosstalk, so keep them away from long parallel runs next to power cords.
Shielding is another area where people overspend. Unshielded twisted pair (UTP) is perfectly adequate in a typical home. Shielded types such as F/UTP or S/FTP only help if the plugs and the equipment are properly grounded, and badly terminated shielding can make noise worse. Consider shielded cable if you run lengths past mains wiring or through a workshop.
On platform nuances, AM5 and LGA1851 boards commonly ship with 2.5GbE, and some enthusiast models include 5G or 10G. If you are pairing one with a Wi-Fi 7 router or a multi-gig switch from the TP-Link range, a Cat6 or Cat6a patch lead means the cable will not hold you back. Series worth looking for include Ugreen Cat6 and Cat6a slim leads, Cable Matters snagless Cat6a, Belkin Cat6 snagless, and StarTech's pure copper ranges. Ubiquiti and similar network-focused makers also sell good bulk cable if you are wiring a house.
Practical things to check before buying
Start with length. Pick a lead 0.5 to 1 metre longer than you measure, because tight bends at the plug are the main cause of intermittent drops. Cat6a has a larger minimum bend radius, so allow for that behind a desk or inside a wall plate.
Check the plug boot. Thick snagless boots are great for protecting the clip, but they can foul on tightly stacked ports on a rear I/O panel or a compact switch. Slim-boot leads solve that. If you are routing a cable through a Computer Cases grommet or around a small-form-factor chassis, check the plug width as well, because shielded plugs are bulkier.
Check the jacket. PVC is standard for patch leads. LSZH (low smoke zero halogen) is better for in-wall or enclosed installs. For permanent runs, buy solid-core cable, not stranded patch cable, and terminate it into keystones. Stranded cable is meant for flexing, and solid core is meant for staying put.
If you are building a full network around a pre-built or a custom rig, browse Networking for switches and routers, and Cables & Connectors for the rest of the leads. Test any long run with a basic cable tester before you close up walls or ceilings. If you are choosing a Computers system for a home office, confirm the onboard LAN speed so you buy the right grade the first time.
Brands and local warranty
For patch leads, reliable names include Ugreen, Cable Matters, Belkin, StarTech, Vention and Orico. For network gear that sits at either end, TP-Link is the safest mainstream pick in Australia. Ubiquiti and Netgear are strong for prosumer setups.
Cables rarely fail, but when they do it is usually a bad crimp or a CCA conductor that has quietly degraded. Under Australian Consumer Law you have guarantees around acceptable quality, regardless of what the box says. Buying from a local retailer means the claim goes through them rather than an overseas marketplace seller, and it is far less hassle. Keep your invoice and the packaging if it is a bulk run.
Frequently asked questions
Is Cat6 or Cat6a better for a gaming PC?
For gaming, either one is more than enough. Latency is determined by your connection, router and ISP, not by cable category. Choose Cat6 for flexibility and price, or Cat6a if you plan to run 10GbE over long distances or want future headroom.
Will a black cable be any slower than another colour?
No. The colour is just the jacket dye. Speed depends on the category, conductor quality and how well the plugs are terminated.
Can I run 2.5GbE over Cat5e?
Yes, in most cases. Cat5e is rated to support 2.5GBASE-T up to 100 metres, so a decent pure copper Cat5e lead will work. Cat6 is a cheap upgrade and gives better margin on longer or noisier runs.
Are flat network cables worth it?
They are handy for running under doors or along skirting boards, and they are fine for short runs. For longer distances or runs beside power cables, a round Cat6 or Cat6a lead gives better crosstalk performance.
How do I spot a poor-quality cable?
Be wary of unusually cheap long cables, vague listings that do not say pure copper, and jackets with no category printing. A very light, thin cable that claims to be Cat8 is another red flag.